The first ever Krissy & Friends and Steamboat Tavern Raingutter Regatta is a boat race event open to everyone!
Entrants (teams or individuals) will need to create a boat (following the specifications below) – you are free to paint and decorate your boat as you chose and prizes will be awarded for design, as well as race winners. Boats can be constructed prior to the day or materials will be provided on the day. Sailboats will race along a specially adapted raingutter filled with water.
The race will take place on Sunday the 19th July at The Steamboat Tavern in Ipswich, as part of the Summer Fundraising Weekend: Day 2. For more information visit the Facebook event page or our events page.
All boats and Captains must be registered by 3pm in order to participate.
Trophies will be awarded to First, Second and Third place winners of both the Race and for Design, so make and name your boat, assign your captain and RACE!
1) Boat Specifications:
- No other form of propulsion besides the sail is allowed.
- Length: up to 18cm (maximum).
- Height: May not exceed 18cm from the top of the deck to the tip of the mast.
- Sail: The sail can be made from any material, but the dimensions should not exceed 14cm high and 10cm wide.
- Width: There is no official maximum or minimum width for the boat although the width of the raingutter is about 12cm wide and the boat must sit down inside the gutter in order to race.
- Weight: No weight restrictions.
- Decorations/Additions: Objects such as sailors, cannons, etc. may be added. All such decorations must be firmly fastened to the boat, and may not be placed in such a manner as to exceed the boat dimensions as listed above.
- Bowsprits (large spars projecting forward from the stem) are prohibited in racing competition, as they extend the overall length of the boat, providing an unfair advantage.
- Body: The body can be made from any materials. It may be shaped, hollowed out, or built up, as long as it meets all other specifications.
- Boat must be able to carry a Krissy & Friends / Steamboat Lego mascot (these will be provided on the day) from start to finish.
Tip – a winning raingutter racer stays on an even keel, moves in a straight line, keeps the bow above water and does not drag.
2) Inspection and Registration:
Before the race begins, all participating “Captains” must check-in with their boats. Here are the pre-race check-in details:
- Before a boat may compete in the regatta, it is subject to a technical inspection by the Raingutter Regatta Commodore, to verify that it meets the prescribed specifications (see 1) Boat Specifications above for details). If a problem is noted, the Captain may be asked to correct it before the boat is registered.
- When the boat passes inspection, it is then registered along with the boat name and the Captain’s name.
- Registration cutoff will be no later than 30 minutes before race start time for all participants. Boats that have not registered by the cutoff deadline (3pm) will not race, so plan to arrive early enough to get your boat registered.
3) Race Procedure:
Every race has to have rules, and ours is no exception. Here’s what to expect:
- Power: No motors, paddles, or other devices allowed. An unattached straw to help direct wind at the sail is allowed, but only the captain can provide the wind.
- Each race heat will involve two equal lengths of raingutter (approximately 3 metres long) filled with water.
- The race heat begins once the official starter has placed the competing boats against the back wall of the gutter and commands the boats to “GO!”
- Pushing the boat forward is NOT allowed while righting a capsized or stuck boat by hand. Pushing may result in disqualification.
- The first boat to reach the finish line (the opposite end of the gutter) is the winner of that heat. The finish line official(s) will have the final and only say in determining the winner. In the unlikely event of a tie, the heat will be rerun.
- The race will be run as a double elimination format, with the winners of each heat advancing until the third, second, and first place winners are determined for each rank.
- First, Second, and Third Places will be awarded either Design or Racing awards.
- Ungentlemanly or unsportsmanlike conduct by any participant or spectator may be grounds for expulsion from the competition and/or the race area.